← Blog

Aerial application order: from contract to report, with airplane and drone

During the season, an agricultural aviation company works with little time and a lot of scattered information. The request comes in by phone, the area arrives as a map sent by message, the rate is in the agronomic prescription and what was actually applied stays in the pilot's notebook. When the customer asks for the report, someone has to put all of that together from memory.

What solves it is treating each job as an application order: a single record that starts with the request, follows the execution and ends in the report. This article shows what to put in it and when.

What the order must answer before the first flight

A well-opened order answers five questions without anyone having to call the office.

For whom and where. The customer and the area or field block, with the crop and the area in hectares. Registering the area once keeps the same block from showing up with three different sizes over the season.

Against what. The target of the application. It looks like a detail, but it is what gives meaning to the choice of product, and it is the first thing people look for when the result is questioned.

With what. The spray mix: each product with its rate per hectare. The total quantity of each one is the rate multiplied by the area, which is exactly why it should not be redone by hand for every order. It is the kind of calculation where the mistake only shows up when product runs short at the airstrip.

How. The application parameters: spray volume, swath width, flight height and equipment.

With whom. The aircraft, the pilot, the agronomist with the CREA registration and the prescription, and the executing technician.

With that in the order, whoever goes to the airstrip carries the same information that stayed in the office.

During execution, record by duty period

The natural unit of work in agricultural aviation is the duty period. A single order usually takes more than one, and each happens under different conditions. So it is worth entering, at the end of each duty period:

  • the hectares applied;
  • the flight hours;
  • the temperature, humidity and wind at the start and at the end.

Recorded on the day, this information costs two minutes. Reconstructed three weeks later, it costs an afternoon and is never reliable.

The immediate gain is progress. By adding up the hectares of each duty period, the company knows at any moment how much is left to close the order, without waiting for the end of the job to find out that the applied area does not match the contracted one.

The report is a consequence

When the order and the duty periods are recorded, the application report stops being separate work. It gathers what already exists: customer, area, crop, products and rates, parameters, the conditions of each duty period and the space for the signatures of the pilot, the technician, the agronomist and the customer.

One caution: the report documents what was recorded. What each agriculture or environmental agency requires of your service is not the subject of this article and must be checked with the operation's technical lead.

With a drone, the order is the same

Applying with a drone changes the equipment, the swath and the volume, but the logic of the job stays the same: there is a customer, an area, a spray mix, an execution and a report. It makes sense for the drone to be in the same fleet and use the same order as the airplane.

What the drone adds is its own maintenance control. The battery decides the availability of the equipment, and the cycles of each one need a history. We cover that in the article on drone fleet management.

On the regulatory side, the treatment differs from the airplane. RBAC 137 (Brazil's regulation for agricultural aviation operations) exempts operations with unmanned aircraft in the open and specific categories of RBAC 100 (137.1). Which category your operation falls into is an analysis for the company itself.

The application and the logbook are different records

The application order records the service provided. The logbook records the flight. Both speak of the same duty period, but they answer different questions for different people, and one does not replace the other. What RBAC 137 asks of the logbook and of the company's records is in the article on the agricultural operator's records.

How this works at Alis

The Alis agricultural aviation module was built around that order:

  • Application order with customer, area or field block, crop, hectares, target, aircraft and pilot;
  • Spray mix with the products and the rate per hectare, and the total quantity calculated;
  • Parameters and people in charge: spray volume, swath width, flight height, equipment, agronomist, CREA, prescription and executing technician;
  • Entry by duty period with hectares, flight hours and temperature, humidity and wind at the start and at the end, and a progress bar for the order;
  • Area and product registries, to choose instead of typing;
  • Application report in PDF, with the signature fields;
  • Drones in the fleet as aircraft, with battery and cycle control.

It is also worth saying what it does not do today. The order calculates the quantity of product, but does not deduct it from inventory. Entering the application does not fill in the logbook. There is no application map and no DGPS integration. And the entry is made on the web: the app screen for use without signal at the airstrip is under development.

The fleet stays in the same system, with a digital logbook, maintenance tracking and downtime forecasting, so maintenance can be planned outside the peak of the season.


This article is for information only and does not replace the regulation in force or the guidance of the operation's technical lead.

Alis Aviation Book a demo